To prevent serious injury, read and understand
For technical questions or replacement parts, please call
4’ x 6’ GREENHOUSE
all warnings and instructions before use
Base Assembly
Contents
GENERAL SAFETY WARNINGS AND PRECAUTIONS
INSPECTION, MAINTENANCE, AND CLEANING
GENERAL SAFETY WARNINGS AND PRECAUTIONS
SPECIFICATIONS
Save This Manual
For technical questions, please call
7. CHECK FOR DAMAGED PARTS. Before using this product, carefully check that it will operate properly and perform its intended function. Check for damaged parts and any other conditions that may affect the operation of this product. Replace or repair damaged or worn parts immediately
For technical questions, please call
4. Fill the hole around the outside of the base with soil
Important-Read the following carefully Before Proceeding
Base Assembly
For technical questions, please call
Cross Section
FRAME ASSEMBLY
Lay out all parts by number prior to assembly
Assembling the Outer Frame
over the heads of the bolts on the Top Doorway Beam. Align the
For technical questions, please call
Assembling the Roof Frame
For technical questions, please call
For technical questions, please call
Assembling the Studs and Braces
The 8 spots requiring a Hold-down Connector
55 are marked with a plus +
For technical questions, please call
inset, and diagram to the right
Spacer 39 between the Support and the Stud. See Figure C
Assembling the Roof Studs and Braces
For technical questions, please call
Insert Bolts 43 into the holes at the bottom of the Side Window
Assembling the Windows
Assembling the Door
For technical questions, please call
front and that the flange where the pane will sit faces down to
For technical questions, please call
Installing the Transparent Panels
For technical questions, please call
Page
Panel Installation Diagram
For technical questions, please call
# = Panel Clip 67 Location
INSPECTION, MAINTENANCE, AND CLEANING
Do not use damaged equipment
PLEASE READ THE FOLLOWING CAREFULLY
2. TO CLEAN Wipe with a damp cloth, using a mild detergent
Page
PARTS LIST
For technical questions, please call
Part
Page
PARTS LIST continued
For technical questions, please call
Part lengths are approximate and most are rounded to the nearest inch