Harbor Freight Tools 94515 Assembling the Studs and Braces, For technical questions, please call

Assembling the Studs and Braces

The 8 spots requiring a

Hold-down Connector

(55)are marked with a plus (+).

8	9
		19
	+	23
+
Viewed from other angle	22	25
19	10
38	+
3	+
39
23
		Figure C

10 23

22

+7

+25

6

+

+

1.Attach the Rear-Left and Rear-Right Studs (8, 9) to the outside of the Rear Floor Plate (16) and Rear Brace (21). Slide a Hold-Down Connector (55) under the base and over the Bolt at each Floor Plate (16) connection.

2.Attach the tops of the Rear Studs (8, 9) to the Rear-Right and Rear-Left Crown Beams (4, 5).

3.Attach a Side Stud (10) in the center of each side to the outside of the frame with an extra Bolt (43) in the slot. Slide a Hold-Down Connector (55) under the base and over the Bolt at each bottom connection.

4.Attach a Side Diagonal Brace (22) from the hole on the Side Floor Plate (34) to the hole on the Side Ceiling Plate (36) on the inside as shown in Figure C. The flange on the Brace should face inward. Attach the center hole of the Brace to the Bolt (43) in the center of the Side Stud (10). Attach the other Side Diagonal Brace (22) to the other side in the same manner as the first.

SKU 94515 For technical questions, please call 1-800-444-3353. Page