Maintenance
1.After each use, wipe all components of the Planishing Hammer with a clean cloth to remove any dirt and grease buildup.
2.To maintain tool life, always lubricate the air line by adding a few drops of pneumatic tool oil to the air line (or Air Inlet) before each use. Or, install the automatic
3.Before each use, drain water out of the air compressor tank and condensation from the air lines. Refer to the Air Compressor Operation Manual.
4.Cover the Planishing Hammer and keep in a clean and dry location.
Parts List
Part | Description | Qty. |
1 | “C” Frame | 1 |
2 | Screw | 1 |
3 | Hammer Head | 1 |
4 | Hammer Sleeve | 1 |
5 | Anvil (small, medium, large) | 3 |
6 | Range Adjust Block | 1 |
7 | Adjustable Pole | 1 |
8 | Screw | 1 |
9 | Stopper Pin | 1 |
10 | Air Hammer | 1 |
11 | Regulator | 1 |
12 | Air Hose | 1 |
13 | Switch Assembly | 1 |
14 | Cover | 1 |
15 | Quick Connector (male) | 1 |
16 | PVC Air Hose | 1 |
17 | Male Thread Fitting | 1 |
18 | Hose Clamp | 2 |
19 | Screw | 4 |
Note: Some parts are listed and shown for illustration purposes only and are not available individually as replacement parts.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
SKU 94847 | For technical questions, please call | Page |
