How to attach the chisels

WARNING: Always make sure this tool is not plugged in before changing the bits.

1.Slide the Bits into the Rotary Hammer with the flat cut-out side facing the Rod (19) as shown in Figure 2.

2.Pull out the Rod (19) while you insert the Bit. See Figure 1. The two bits both have a flat space on the shaft that must be turned horizontally when it is inserted. See Figure 2. Turn the Rod (19) clockwise 180° to lock the Bit into place. The Bit should move in and out after it is locked but should not come out.

Rod (19)

Flat area of Bit

Figure 1

Figure 2

OPERATING INSTRUCTIONS

How to turn on the Rotary Hammer

1.To turn on the Rotary Hammer squeeze the Switch (107) shown below in Figure

3.There is a latch on the upper part of the switch that locks the switch on.

Switch (107)

Figure 3

SKU 94944

PAGE 11

Page 11
Image 11
Harbor Freight Tools 94944 Operating Instructions, How to attach the chisels, How to turn on the Rotary Hammer