How to add grease to the gears
Every 100 hours of use it is recommended that you add wheel bearing grease to the gears. To get access to the gears, you must remove Crank Case Cover (40) by removing the six machine screws (37). Next rub wheel bearing grease on all the gears in the chamber. Replace the Crank Case Cover (40) using the same machine screws (37) that held it on. See the assembly diagram on page 17 to identify the parts.
TROUBLESHOOTING
Problem | Cause | Action |
Motor doesn’t rotate | Disrupted power | Check power supply |
when switched on. | Poor switch contact | Have switch repaired |
| Worn carbon brushes | Replace brushes |
Overheated gearbox | Dull Drill Bit | Replace or sharpen the Drill Bit |
| Excessive use | Allow tool to cool down |
| Gears need grease | Add grease to the gears |
NOTE: Other than changing or cleaning the carbon brushes, all other internal repairs should be done by a qualified service technician.
SKU 94944 | PAGE 15 |
