Harbor Freight Tools 94944 Important Read before use, Chipping in a straight line

OPERATING INSTRUCTIONS

WARNING: Always wear ANSI-approved impact safety goggles. Wear a full face shield if you are producing metal filings or wood chips. Wear an ANSI-approved dust mask or respirator when working around metal, wood, and chemical dusts and mists. Always wear ear protection. Ear protection is required for any other persons in the work area.

WARNING: Be aware of flying concrete chips. Keep all spectators clear of the work area.

WARNING: Do not operate this tool if you have back, neck, wrist, or other conditions or injuries that will be aggravated by the severe jerking forces that this tool exerts upon its operator.

WARNING: If the Rotary Hammer ever gets out of your control, immediately release the Switch (107).

NOTE: Use the weight of the Rotary Hammer to help you break up concrete. Use the tool in the vertical position whenever possible.

Important - Read before use

This Rotary Hammer may have decreased performance for a brief period at the beginning of each use. This warmup period lasts approximately 3-5 minutes. This happens because the grease inside the tool may be somewhat thick, preventing the tool from operating at full efficiency while the motor is cold. This is perfectly normal and does not indicate a problem. To help reduce this effect, we recommend storing this equipment in temperatures no lower than 50-60° F.

Chipping in a straight line

1.Use chalk or another suitable writing material and mark you work surface to delineate the area you intend to hammer.

2.Plug in the Rotary Hammer.

3.Grasp the handles firmly with both hands. When you are sure that no people or animals are in the vicinity, and it’s safe to begin, depress the Switch (107).

4.The Rotary Hammer will begin to break the top layer of concrete. If you push down, it will begin to break the next layer as well.

5.Keep moving the Rotary Hammer along the line you want to section, breaking concrete as you go. If the Rotary Hammer jumps off of the line or section, release the Switch (107) and reposition the Rotary Hammer.

6.When you are finished, release the Switch (107) and unplug the Rotary Hammer.

SKU 94944 PAGE 12