Harbor Freight Tools 95592 - 1 HP, 95591, 95593 - 1.5 HP Do not pump hazardous materials

Models: 95592 - 1 HP 95591 - .75 HP 95593 - 1.5 HP 95592 95593 95591

1 14
Download 14 pages 9.23 Kb
Page 5
Image 5

6.Do not pump hazardous materials.

Do not pump explosive or flammable materials such as fuel, oil, kerosene, gasoline, etc. Do not pump in close proximity to flammable or explosive materials. Do not pump fats, oils, salt or waste water. This Pump is designed to move clean or dirty water only. Do not pump water hot- ter than 95 degrees Fahrenheit.

7.Secure the discharge pipe (not in- cluded) to a solid surface to ensure the stability of the Pump.

8.Position the Pump on a flat, level, solid surface.

Drip Loop

OUTLET

DEVICE

CORD

9.Arrange a “drip loop” in the Power Cord connecting the Pump to a 115 volt, GFCI electrical outlet. A drip loop is that part of the Power Cord below the level of the outlet to pre- vent water from traveling along the Power Cord and coming in contact with the outlet. If the Power Plug or electrical outlet does get wet, do not unplug the Power Cord. Disconnect the fuse or circuit breaker that sup- plies power to the Pump. Then, unplug the Power Cord and examine for presence of water in the outlet.

10.If necessary, have a certified elec- trician install (within 10 feet of where the Pump will be located) a 115 volt, GFCI electrical outlet that is dedicated only to the Pump.

Any outlet should be above the water line.

11.NEVER raise or lower the Pump by its electrical Power Cord.

12.In cold weather, when the Pump is not in use, protect the interior of the Pump from freezing by draining the water and pumping a permanent type automobile anti- freeze containing a rust inhibitor through the system. A 50% mixture with water is recommended. Be sure to flush the system with a neutralizing liquid prior to re-use of the Pump.

13.If an extension cord is used (for temporary use only) connections must not come in contact with wa- ter or any wet surfaces.

14.Prior to use, and periodically thereafter, check to make sure all connections are tight and secure.

15.Industrial applications must follow OSHA requirements.

16.People with pacemakers should consult their physician(s) before use. Electromagnetic fields in close proximity to heart pacemak- er could cause pacemaker interfer- ence or pacemaker failure.

17.The warnings and cautions dis- cussed in this manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.

SKU 95591/95592/95593

For technical questions, please call 1-800-444-3353

PAGE 5

Page 5
Image 5
Harbor Freight Tools 95592 - 1 HP, 95593 - 1.5 HP, 95591 - .75 HP Do not pump hazardous materials