Maintenance And Servicing
Cleaning and Removing the Staple Channel
1.Push the Retaining Clip at the front of the Staple Gun forward to release the Staple Channel. Pull the two tabs (located midpoint on the bottom of the Staple Gun) toward the back of the Staple Gun.
2.The Staple Channel is now free of the Staple Gun and can be cleared of any jammed fasteners and debris.
Cleaning, maintenance, and lubrication
1.BEFORE EACH USE, inspect the general condition of this product. Check for loose screws, cracked or broken parts and any other condition that may affect its safe operation.
2.Remove dirt and debris from the Staple Gun using a clean, soft cloth. Do not use flammable corrosive or abrasive solvents to clean the Staple Gun.
Troubleshooting
Problem |
| Possible Causes |
| Probable Solutions |
|
|
|
|
|
Staple Gun does not staple | 1. | Staples not loaded | 1. | Verify that staples are loaded into |
|
| correctly. |
| the Magazine Unit flat and with |
| 2. | Magazine Unit not fully |
| prongs facing upward. |
|
| and properly inserted into | 2. Check that Magazine Unit is fully | |
|
| Staple Gun. |
| inserted. |
| 3. | Lever not pulled |
|
|
|
| completely up and then |
|
|
|
| fully pressed down. |
|
|
|
|
|
|
|
Stapler jams during operation | 1. | Staples jammed in | 1. | Pull out the Staple Channel. |
|
| channel. | 2. | Remove jammed fasteners |
|
|
| ||
|
|
|
| from the channel. You may |
|
|
|
| need to use |
|
|
|
| ers (not included). |
|
|
| 3. | Make certain that you are |
|
|
|
| using correct size fasteners. |
|
|
| 4. | Replace Staple Channel. |
|
|
|
|
|
SKU 96755 | For technical questions, please call | Page |
