Specifications
Welding Current | 30 ~ 120 amps | |
|
| |
| 20% at 105 amps; | |
Duty Cycle | 40% at 75 amps; | |
90% at 50 amps; | ||
| ||
| 100% at 30 amps | |
Input Power | 230 VAC, 21 amps | |
(Peak) at 60 Hz | ||
| ||
Open Circuit Voltage | 36 VDC | |
(max) | ||
| ||
Thermal Overload | Automatic shutdown | |
and restart after cool | ||
Protection with Light | ||
down | ||
| ||
| 0.023 to 0.030 inch | |
| steel and stainless | |
Wire Size | steel; 0.030 to 0.035 | |
| inch flux core and | |
| aluminum | |
Welding Capacity | 22 gauge to 3/16” | |
Steel | ||
| ||
Wire Spool Size | 2 lb. Spool | |
Weight | 62.2 lbs. |
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
List of contents
Description | Qty |
Dual MIG Welder | 1 |
Wheel | 2 |
Axle | 1 |
0.030” (0.8mm) Welding Tip | 1 |
0.040 (1.0mm) Welding Tip | 1 |
2 Pounds (0.030”) Flux Core Wire | 1 |
Hand Held Shaded Face Shield | 1 |
Brush Hammer | 1 |
Welder Tip Close End Wrench | 1 |
24” Strap For Gas Bottle | 2 |
Initial Set Up
Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
WARNING To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Assembly
1.Slide the Axle (29) through the holes at the rear of the unit.
2.Secure both Wheels (28) to the Axle with the Locking Rings (42).
3.Lift up the Side Panel B (1) to expose the wire spool and Wire Feed Mechanism (10). Pull back on the Feed Tensioner (CC) to free the Feed Tension Arm (DD) and lift it up. Remove Wire Feed Wheel Cover (AA) screws, pull out the cover, and pull out the Wire Feed Wheel (BB).
See photo page 10.
4.Note the two parallel grooves (one is wider) on the circumference of the Wire Feed Wheel (BB). On the sides
SKU 97503 | For technical questions, please call | Page 9 |
