Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Set Up Instructions
Read the entire Important Safety Instructions section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Assembly
1.The ATV Spreader comes partially assembled.
2.Mount the two sides of the Frame Rail (21) to the Hopper Assembly (8) using Screws M5 x 35 (14).
3.Position the Gauge Assembly (22) to either Frame Rail (21) based on whether the Hopper Assembly (8) is to be mounted on the front, or rear rack of the ATV. If mounted on the rear rack, the Control Handle (25) should be on the right Frame Rail (21). If mounted on the front rack, place the Control Handle (25) on the Left Frame Rail (21). See Figure 1 below.
Figure 1
Switch Box Installation:
WARNING: To prevent serious injury, make sure the ATV is OFF before install- ing The Switch Box Assembly (31) .
1.Attach the Switch Box Assembly (31) to your ATV. Route cable ties through the two slots located on the Switch Box Assembly (31) and connect them onto the ATV Frame.
NOTE: Make sure the Switch Box As- sembly (31) is secure before proceeding.
2.Connect the ATV Battery Terminals
3.Connect the Motor Terminal
4.Connect the ATV Battery Terminals
REV 08g; 09a
SKU 99621 | For technical questions, please call | Page 4 |
