Harbor Freight Tools 99623 manual Operating Instructions, See Figure J

11. Adjust the position of the two Lock Nuts (24) on the Control Rod (25), making sure the holes at the bottom of the Hopper (16) line up with the holes in the Shut Off Plate (27) prop- 4. erly. (See Figures I and J.)

one Lock Nut (24).

(See Figure I.)

HOPPER

(16)

FIGURE I

FLAT

WASHER

(48) LOCK NUT (24)

SHUT OFF PLATE (27)

10.Push down on the Adjust Handle (6) to its lowest position.

(See Figure J.)

	“R” PIN
	(17)
	ADJUST
	HANDLE
PINION	(6)
SHAFT		WING
	FIGURE J	NUT
		(10)
		LOCK NUTS
		(24)
		“R” PIN (17)

PUSH FORWARD.

IMPELLER MUST TURN

IN THIS DIRECTION.

12.Pull up on the Adjust Handle (6) to its upper position, making sure the holes in the Hopper (16) and the holes in the Shut Off Plate (27) are 100% open.

(See Figure J.)

13.Adjust the position of the Wing Nut

(10).By doing so, you are able to con- trol the size of the holes you need.

(See Figure J.)

14.Insert the “R” Pin (17) into the Pinion Shaft on the Gear Box and Axle As- sembly (39). Make sure the Impeller

(42)is turning in the correct direction as indicated by the arrow in the illustration.

(See Figure J.)

Operating Instructions

Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before assembly or use of this product.

1.Before operating the Spreader make sure to wear ANSI-approved safety impact glasses, NIOSH-approved dust mask/respirator, and heavy duty work gloves.

2.Remove the Screen (14) on the Hopper

(16) and fill the Hopper with the materi- al you wish to apply. Do not exceed 50 pounds of material. Then replace the Screen. (See Figure K, next page.)

3.Refer to the manufacturer’s recom- mended flow rate (0 to 5, typically shown on the bag/container of the material being applied).

Adjust the flow rate on the Gauge and

Lever Assembly (4) to that of the mate-

SKU 99623 For technical questions, please call 1-800-444-3353. Page 7