HKTS 60BQ
Speaker Placement
NOTE: If you’re running the speaker wire through the wall, you can bring it out directly behind the bracket location and insert it through the bottom opening in the wall portion of the bracket, as shown in the illustration. Running the wire in this way will keep the wire completely hidden from view once the installation is complete.
Insert Wire into Bottom Opening
Bring Wire out through Here
5.If you’re not running the speaker wire through the wall, insert it through the wall portion of the bracket, as shown in the illustration.
6.Pass the speaker wire through the speaker portion of the
8.Connect the speaker wire to the speaker terminals as shown in the illustration:
a)Press down on the top of the terminal to open the connection hole.
b)Insert the wire’s bare end all the way into the hole.
c)Release the terminal to secure the wire.
Insert the conductor with the colored band into the speaker’s red ( + ) terminal, and insert the other conductor into the speaker’s black ( – ) terminal.
| + | – |
|
|
|
| |
A. Push Down on Cap | B. Insert Bare Wire | C. Release Cap | |
to Open Hole | into Open Hole | to Secure Wire |
IMPORTANT: Make sure the ( + ) and ( – ) bare wires do not touch each other or the other terminal. Touching wires can cause a short circuit that can damage your receiver or amplifier.
9.Slide the speaker portion of the
•Push the bracket all the way onto the speaker until it snaps into place.
•Pull any slack speaker wire back through the bracket as you slide the bracket onto the speaker.
Push Down Evenly on Both Sides of Bracket
Fit Bracket Grooves onto Speaker Rails
Bring Wire In through Here
Bring Wire out through Here
7.If you have not already removed the speaker’s base, do so by pulling it straight off the speaker, as shown in the illustration. Applying even pressure to both sides of the base will allow it to slide off smoothly.
10.Slide the speaker onto the bracket’s wall section, as shown in the illustration. Pull any slack speaker wire back through the bracket’s wall section.
Slide Speaker onto
Apply Pressure Evenly | Lift Base Straight |
to Both Sides of Base | off Speaker |
11.Fit the metal stop plate into the recess on the bottom of the bracket with the pad facing the bracket, and fasten it to the bracket using two of the supplied screws. Fastening it will prevent the speaker from detaching from the bracket and will hold the speaker’s position as you rotate it.
CAUTION: Before making speaker connections, be sure that your receiver or amplifier is turned OFF and its AC cord is unplugged from the AC outlet.
Stop Plate Supplied Screws
6