Harman-Kardon owner manual HKTS 60BQ

HKTS 60BQ

Setup Instructions

Front Left Center Front Right

Front Left	Center	Front Right
Speaker Cable	Speaker Cable	Speaker Cable
(White Bands)	(Green Bands)	(Red Bands)

– + – + – +

FRONT		SURROUND		CENTER
+	–	–	+	+	–
	RIGHT
	LEFT			SUB
+	–	–	+	LFE OUT
							PL0004-01001
							Subwoofer
Receiver
					LFE/Trigger Cable
	Surround Left				(Purple Ends)
	Speaker Cable
	(Blue Bands)
	–	+			Surround Right	–	+
					Speaker Cable
					(Gray Bands)

Surround	Surround
Left	Right

Connecting the Subwoofer to a Receiver or Preamp/Processor With a Dedicated Subwoofer Output

Use this installation method for receivers and preamp/processors that have a dedicated subwoofer output with low-pass filtering (also called bass management). If the dedicated subwoofer output does not have low-pass filtering, follow the instructions in Connecting the Subwoofer to a Receiver or Preamp/Processor With Line Outputs, on page 9.

Use the LFE (purple) connector of the supplied combination LFE and trigger cable to connect the HKTS200SUB’s Line-Level LFE In Jack 5 to the dedicated subwoofer output (or LFE output) of your receiver or preamp/processor.

Connect each satellite speaker and the center speaker to the corresponding speaker terminals on your receiver or amplifier.

Configure your receiver or preamp/processor’s setup menu for Subwoofer ON, and set the front left, front right, center and surround speakers to Small. After you have made and verified all connections, plug the HKTS200SUB’s AC Power Cord 8 into an active AC outlet.

8