HKTS 60BQ
Setup Instructions
Front Left | Center | Front Right |
Front Left | Center | Front Right |
Speaker Cable | Speaker Cable | Speaker Cable |
(White Bands) | (Green Bands) | (Red Bands) |
– | + | – | + |
FRONT | SURROUND | CENTER | |||
+ | – | – | + | + | – |
|
|
|
| ||
| RIGHT |
|
|
| |
| LEFT |
| |||
|
| OUTPUTS | |||
|
|
| |||
+ | – |
| L |
| R |
– | + |
|
| ||
|
|
|
| ||
Receiver |
|
|
|
| |
| Surround Left |
|
|
| |
| Speaker Cable |
|
|
| |
| (Blue Bands) |
|
|
| |
| – | + |
|
| Surround Right |
|
|
| Speaker Cable | ||
|
|
|
|
| (Gray Bands) |
– | + |
Subwoofer
RCA Cable
(Not Supplied)
(Red and White Ends)
– | + |
Surround | Surround |
Left | Right |
Connecting the Subwoofer to a Receiver or Preamp/Processor With Line Outputs
Use this installation method for receivers and preamp/processors that do not have
adedicated subwoofer output but do have
If you’re connecting to a receiver with left and right line outputs that are not connected to amplifier inputs, connect the LFE (purple) connector of the supplied combination LFE and trigger cable to one of those outputs and to either of the HKTS200SUB’s
If you’re connecting to a receiver or preamp/processor with left and right line outputs that are connected to amplifier front left and front right inputs, connect
the single line outputs. Connect one of the
Connect each satellite speaker and the center speaker to the correspond- ing speaker terminals on your receiver or amplifier.
Configure your receiver or preamp/processor’s setup menu for Subwoofer ON, and set the front left, front right, center and surround speakers to Small.
After you have made and verified all connections, plug the HKTS200SUB’s AC Power Cord 8 into an active AC outlet.
9