REMOTE CONTROL FUNCTIONS
Mute Button: Press to mute the AVR’s speaker and headphone outputs. To end the muting, press this button, adjust the volume, or turn off the receiver.
Channel/Page Control: When the tuner has been selected, this control changes a preset radio station. While operating a cable, satellite or HDTV set- top box or a television, press these buttons to change channels.
Transport Controls: These buttons are used to control source playback and The Bridge III.
Record Button: Use this button to make recordings when an audio or video recorder is in use.
Setup Button: Press to display the AVR’s Main Menu, or to switch the remote to AVR device mode.
Info Settings Button: Press to display the AVR’s Info Menu, which contains the settings for the current source.
Sleep Settings Button: Press to activate the sleep timer, which turns off the receiver after a programmed period of time of up to 90 minutes. Each press decreases the timer by 10 minutes, ending with the “Sleep Off” message.
Zone Selector: Use this switch to select whether AVR commands will affect the main listening area (Zone 1) or the remote zone of a multizone system (Zone 2). For normal operation, leave the switch in the Zone 1 position.
Learn (AVR 460 only): The AVR remote is capable of “learning” individual IR codes from the original remote that came with a source device. See page 24 in the Installation section.
Zone 2 Remote Control (AVR 460 only)
The Zone 2 remote control is used in the remote zone of a multizone system with an IR receiver connected to the Zone 2 IR Input or an
The Zone 2 remote may also be used in the main listening room to directly control the AVR 460 and Harman Kardon DVD, CD or tape players. When the Zone Selector is pressed to switch the remote to Zone 1 mode (the Zone Indicator will turn green), the power, volume and mute controls will only affect the main listening area. To control operation for the remote zone, press the Zone Selector so that the Zone Indicator turns red.
The Zone 2 remote requires two AAA batteries (included) that are installed in the battery compartment on the back of the remote. Make sure to observe proper polarity by matching the + and – symbols on the batteries to the symbols printed inside the compartment.
The following explanations describe the buttons that are not similar in function to the main remote control, or are found on the Zone 2 remote control only. For explanations of all other Zone 2 remote control functions, see the descriptions above that cover functions that are common to the two Remote Controls as well as functions available on the Main Remote Control only.
Power: Press to turn the AVR 460 on or off. The AVR also turns on its multizone system automatically when any of the Input Selectors is pressed, even if the AVR itself is in Standby mode. When in the main listening room, press any Input Selector or the AVR Selector to turn on the AVR 460.
Zone Selector and Zone Indicator: Each press of the Zone Selector determines whether the AVR commands will affect the main listening area (Zone 1) or the remote zone (Zone 2). The Zone Indicator will turn green when Zone 1 has been selected, and red for Zone 2. The Zone Indicator will also light briefly whenever any button is pressed.
ENGLISH
Instructions for users on removal and disposal of used batteries. Specification of included battery types.
These symbols shown on the product, the packaging or in the manual or separate information sheet mean that the product itself, as well as the batteries included or built into the product, should never be thrown away with general household waste. Take them to suitable collection points, where proper treatment, recycling and recovery take place, in accordance with national or local legislation, or European Directives 2002/96/EC and 2006/66/ EC.
Correct handling of the product and batteries to be disposed of helps to save resources and prevents possible negative effects on the environment or human health.
The batteries included with your equipment may be Alkaline, Carbon Zinc/ Manganese or Lithium (button cells) type. All types should be disposed of according to the above instructions.
To remove the batteries from your equipment or remote control, reverse the procedure described for inserting batteries in the Owners Manual.
For products with a
13
