Harman-Kardon HKTS20, HKTS30 manual Left Front Center, Subwoofer

Left Front Center Right Front

Front Left	Center	Front Right
Speaker Cable	Speaker Cable	Speaker Cable
(White Bands)	(Green Bands)	(Red Bands)

– + – + – +

FRONT		SURROUND			CENTER
+	–		–	+	+	–
	RIGHT
	LEFT				SUB
+	–		–	+	LFE OUT
								PL0004-01001
								Subwoofer
Receiver
						LFE/Trigger Cable
		Surround Left				(Purple Ends)
		Speaker Cable
		(Blue Bands)
	–		+			Surround Right	–	+
						Speaker Cable
						(Gray Bands)

Left	Right
Surround	Surround

Connecting the Subwoofer to a Receiver or Preamp/Processor With a Dedicated Subwoofer Output

Use this installation method for receivers and preamp/processors that have a dedicated subwoofer output with low-pass filtering (also called bass management). If the dedicated subwoofer output does not have low-pass filtering, follow the instructions in Connecting the Subwoofer to a Receiver or Preamp/Processor With Line Outputs, on page 9.

Use the LFE (purple) connector of the supplied combination LFE and trigger cable to connect the HKTS200SUB’s Line-Level LFE In Jack 5 to the dedicated subwoofer output (or LFE output) of your receiver or preamp/processor.

Connect each satellite speaker and the center speaker to the corresponding speaker terminals on your receiver or amplifier.

In your receiver or preamp/processor’s setup menu, configure it for Subwoofer ON, and set the front left, front right, center, and surround speakers to Small. After you have made and verified all connections, plug the HKTS200SUB’s AC Power Cord 8 into an active AC outlet.

8