Kenmore 153.316555 Installation Instructions, contd, Installation Checklist, Model Rating Plate

Installation Instructions	(cont'd)
Installation Checklist	COLD
HOT

•Whether or not the element conversion is made, the model raring plate must be marked• Using a hard point ink pen, check the appropriate block within the model rating plate, which is located adjacent to the lower access panel.

•Is the fuse or circuit breaker size correct as shown in the chart in the "Product Specifications" section?

•Are the wires from the circuit breaker or fuse service to the

water heater's junction box on the correct wire size (gauge) as shown in the chart in the "Product Specifications" section?

•Is the new temperature-pressure relief valve properly installed, and piped to an adequate drain? See Temperature-Pressure Relief Valve" section.

PRESSURE

RELIEF VALVE TEMPERATURE.

•Is the water heater completely filled with water? See _Filling

the Water Heater" instructions in the _Installation

Instructions section.

•Will a water leak damage anything? See "Facts to Consider About the Location" section•

•Are the cold and hot water lines connected to the water heater

correctly? See "Water Piping" instructions in the "Installation Instructions section•

•Is there adequate clearance for maintenance around the water heater?

•Do you need to call your electric company to check your wiring?

DISCHARGE

PIPE

(Do not cap or

plug)

6" AIR GAP

FLOOR DRAIN

MODEL RATING PLATE

15