Harman-Kardon HKTS20, HKTS30 manual Insert Wire into Bottom Opening

NOTE: If you’re running the speaker wire through the wall you can bring it out directly behind the bracket location and insert it through the bottom opening in the wall portion of the wall-mount, as shown in the illustration. This will keep the wire completely hidden from view once the installation is complete.

Insert Wire into

Bottom Opening

Bring Wire Out through Here

5.If you’re not running the speaker wire through the wall, insert it through the wall portion of the wall-mount bracket as shown in the illustration.

6.Pass the speaker wire through the speaker portion of the wall-mount as shown in the illustration.

Bring Wire In through Here

Bring Wire Out through Here

8.Connect the speaker wire to the speaker terminals as shown in the illustration:

a)Press down on the top of the terminal to open the connection hole.

b)Insert the wire’s bare end all the way into the hole.

c)Release the terminal to secure the wire.

Insert the conductor with the colored band into the speaker’s red ( + ) terminal, and insert the other conductor into the speaker’s black ( – ) terminal.

+ –

A. Push Down on Cap to	B. Insert Bare Wire into	C. Release Cap to Secure Wire
Open Hole	Open Hole

IMPORTANT: Make sure the ( + ) and ( – ) bare wires do not touch each other or the other terminal. Touching wires can cause a short circuit that can damage your receiver or amplifier.

9.Slide the speaker portion of wall-mount onto the speaker as shown in the illustration. Fit the grooves on the mount onto the rails in the speaker, and apply even pressure on both sides of the mount so it slides straight onto the speaker.

•Push the mount all the way onto the speaker until it snaps into place.

•Pull any slack speaker wire back through the mount as you slide the mount onto the speaker.

Push Down Evenly on Both Sides of Bracket

Fit Bracket Grooves onto Speaker Rails

10.Slide the speaker onto the mount’s wall section as shown in the illustration. Pull any slack speaker wire back through the mount’s wall section.

7.If you have not already removed the speaker’s base, do so by pulling it straight off the speaker, as shown in the illustration. Applying even pressure to both sides of the base will allow it to slide off smoothly.

Apply Pressure Evenly	Lift Base Straight
to Both Sides of Base	off Speaker

Slide Speaker

onto Wall-Mount

11.Fit the metal stop plate into the recess on the bottom of the mount with the pad facing the mount, and fasten it to the mount using two of the supplied screws. This will prevent The speaker from detaching from the bracket and will hold the speaker’s position as you rotate it on the mount.

CAUTION: Before making speaker connections, be sure that your receiver or amplifier is turned OFF and preferably, its AC cord is unplugged from the AC outlet.

Stop Plate

Supplied Screws

6