Harman-Kardon RCP 6 owner manual Functions with the various product types, Dvd Cd, Cd-R

PROGRAMMING SOURCES

Table 1 – Remote Control Codes

Source Input	Product Type	Remote Control Code
	(circle one)
Video 1	VCR, PVR
Video 2	Cable, Satellite
Video 3	TV
Video 4	TV
HDMI 1	DVD, VCR/PVR,
	Cable, Satellite
HDMI 2	DVD, VCR/PVR,
	Cable, Satellite
DVD*	DVD
CD	CD, CD-R
Tape	Cassette

*Do not reprogram the DVD Source Selector unless you are replacing the DVD player included in the CP 60 system with another product.

If you are unable to locate a code set that correctly operates your source device, it will not be possible to use the RCP 6 remote to control that device. However, you may still connect the source to the AVR 247 and operate it using the device’s original remote control.

Most of the button labels on the remote describe the button’s function when used to control the AVR 247 (gray labels) or DVD 38 (blue labels). However, the button may perform a very different function when used to control another device. Refer to the Remote Control Function List, Table A1 in the Appendix, for a list of each button’s

functions with the various product types.

If you wish, you may program macros, which are preprogrammed code sequences that execute many code commands with a single button press. You may also program “punch-through” codes, which allow the remote to operate the volume, channel or transport controls of another device without having to switch the remote’s device mode. See page 12 for instructions on these advanced programming functions.

NOTE: The RCP 6 remote is preprogrammed to operate the transport controls of the DVD 38 when the AVR or VID2 or VID3 device is selected. You may change this punch-through programming at any time, as explained in the Advanced Functions section.

10 10