Harman Stove Company 929BV manual Connecting the Cordset, Connecting Optional Thermostat

connecting the CORDSET

The Clarity B-Vent Gas Heater must be installed in ac- cordance with local codes or, in the absence of local codes, with the most recent edition of the National Electrical Code ANSI/NFPA 70, or the current Canadian Electrical Code C22.1.

NOTE: The convection fan requires a 120 VAC supply for operation, but the heater can be operated without the fan as in the case of a power outage.

Plug the 3-prong grounded electrical cord plug into the wall.

WARNING: This heater is equipped with

athree-pronged grounding plug that should be plugged directly into a prop- erly grounded receptacle. Do not cut or remove the grounding prong from the pluG.

Terminal strip for thermostat connec- tion

Rear view of Clarity

Connecting the

Optional Thermostat

If connecting the optional thermostat, it must be plugged into the terminal strip located on the left side near the bot- tom of the stove.

When installing a millivolt control sys - tem, use only a special low resistance thermostat.. Do not use a regular heating thermostat.

Be sure that all electrical connections are clean, free from corrosion, and tight. Inspect connections periodically to confirm that no corrosion has built up over time.

When properly installed and maintained, a millivolt control system should give many years of trouble-free service.

It is important to use wire of a gauge proper for the length of the wire:

RECOMMENDED WIRE GAUGES

Maximum	Wire
Length	Gauge
100'	14
60'	16
40'	18
25'	20
15'	22