Harman Stove Company Advance Pellet Stove manual Maintenance Combustion Intake Cover

Maintenance - Combustion Intake Cover

CoverRetainer Handle

Fig. 46

These surfaces must be even to	Combustion
close retainer handle.	Intake Cover

Cleaning and Maintenance for the

Combustion Intake Cover

You will need to remove the combustion intake cover to clean the fan blades and rear flue tube.

Figure 46

Rotate the retainer cover handle counter-clockwise upward as far as it will go (approximately 90o).

Fig. 47

Intake Cover Handle	Right Side Tab
	Right Side Retaining Slot

ESP Probe (in rear of flue tube)

Figure 47

Hold the intake cover handle and pull until the side of the cover at the retainer handle end comes away from the stove body, approximately 15-20o, slide the right side tab out of the retaining slot.

Figure 48

Clean and inspect the fully exposed combustion fan blade and flue tube.

Reinstall the combustion intake cover by first sliding the right side tab into the retainer slot seen in Figure 47.

Rotate the cover inward until the cover fits into its hole.

Make sure the two faces (Fig.46) of the cover and retainer spacer are even and rotate the retainer handle clockwise until it stops.

	CAUTION
	Excessive cleaning force could bend the
	small stainless steel ESP Probe, causing
Fig.48	damage.
Combustion Fan Blade

23