Rockin’’ |
|
Micro Boombox™ | Ages 5 & Up |
Instruction | Asst No. 02014 |
Playing your HitClip® | |
1.Slide Micro | 2. Press the Play |
Music Clip into | button to start |
the Boombox. | and stop music. |
Battery Replacement
1. Your Rockin’ Micro Boombox™ comes with batteries already installed.
2. To replace batteries, unscrew battery door lock. 3. Remove exhausted
batteries and dispose of properly.
4.Insert 3 new AAA/LR03 batteries.
5.Replace battery door and tighten screw.
To ensure proper function
-Do not mix old and new batteries.
-Do not mix alkaline, standard (carbon zinc), or rechargeable batteries
-Battery installation should be done by an adult.
-
-Rechargeable batteries are to be removed from the toy before being recharged (if removable).
-Rechargeable batteries are only to be charged under adult supervision (if removable).
-Only batteries of the same or equivalent type as recommended are to be used.
-Batteries are to be inserted with correct polarity.
-Exhausted batteries are to be removed from the toy.
-The supply terminals are not to be
-Do not dispose of batteries in fire, batteries may explode or leak.
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1)This device may not cause harmful interference, and
(2)This device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is needed.
-Consult the dealer or an experienced radio/TV technician for help.
