Service
Continuous projection
You can either run automatic slide shows using the
Note (EKTAPRO 4020/5020/7020 Projector)
In order to avoid "dark pause" it is recommended that the slide tray is filled as completely as possible.
KODAKEKTAPRO9020Projector You can immediately bring the tray back to the zero position after the last slide with the help of the automatic zero positioning fea- ture. This is useful when continuous pro- jection is required using only a few slides. By pressing the switch (8), you can activate the automatic zero positioning.
Replacement of a defective lamp
WARNING:
Before pulling out the lamp module, switch off the projector and unplug the mains lead first!
For lamp replacement let the module cool down before touching the lamp and the surrounding area. Do not place the hot lampmodule on heat sensitive surfaces. Glass may shatter. Wear gloves. Keep glass covered.
Do not touch the small bulb or the mirror surface! If you accidentally get finger prints on them, remove marks with a soft cloth moistened with rubbing alcohol.
Replacement of a defective lamp is very easy with your EKTAPRO Slide Projector:
1. | 4. |
|
3.
2.
1.Press down and hold down the lamp module release (28) and...
2.... pull out the lamp module (20).
.Push the lamp ejector lever down so that it clears the retaining clip.
Note:
For your projection requirements you have a choice of 3 lamps with different brightness and lamp life (see Accesso- ries page 35).
3.Push the ejector lever completely to the side.
The defective lamp will come free of it’s holder.
4.Remove the defective lamp and in- sert the new lamp.
.Push the ejector lever back to the right and press down until it locks into its hold- ing.
.Push the lamp module back into the projector until it locks.
32
