Electrical System
PowerVoltage:ACONLY!
Different power voltages are adjustable via the removable fuse link.
(120,220,230,240V)
Frequency:
50/60Hz
Performance: approximately 380 W
Fuses:
Primarycircuit:
1 x T 2A L/250V for 220, 230 and 240V or 1 x 4 A slow blow/250V for 120V Secondary circuit:
For10V:
1xT1.25AL/250V(5x20mm)
(ForUSAandCanada:1x1.25Aslowblow/ 250V)
For24V:
1 x T 2.0 A L/250V (5x 20 mm)
(For USA and Canada: 1 x T 2.8 A slow blow/250V)
SupplyVoltageforExternalUnits: Provisionof12V/50mA(DC)directvoltage on the
Control system
External:
•
• P-Bus-out
•Slot for modules
•
ADDRESS Switch
Rotary switch to set projector address
Slide Change Time:
0.88sec (independent of mains voltage and frequency).
Slide Access Times :
<3.5 sec for the longest search run.
Connectors and
Interfaces
P-Bus-in and P-Bus-out:
The following pin connections are used for data transmission:
Pin 2: Transmit Data TxD
Pin 3: Receive Data RxD
Pin 5: Signal ground
5 4 3 2 1
9 8 7 6
EKTAPRO 7020/9020 Projectors:
The
Slot for Module:
Pin a1: | SDA | Pin b1: SCL |
Pin a2: | - | Pin b2: PLL_DISS |
Pin a3: SLOT_232_R | Pin b3: SLOT_232_T | |
Pin a5: SLOT_A | Pin b4: STBY_DIS | |
Pin a6: SLOT_C | Pin b5: SLOT_B | |
Pin a8: | 12 VDC | Pin b6: SL_DISS |
Pin a9: | 34 VDC | Pin b8: VSS 12 |
Pin a10:24 VAC_N | Pin b9: VSS 34 | |
|
| Pin b10: 24 VAC_L |
a10 a9 a8 a7 a6 a5 a4 a3 a2 a1
b10 b9 b8 b7 b6 b5 b4 b3 b2 b1
8-pin Standard Projector Socket:
(For connecting the KODAK EKTAPRO Remote Systems or KODAK EKTAPRO Twin Socket Adapter).
Pin 1: 12 VDC |
| 7 | |||
Pin 2: Gnd |
| ||||
8 | 6 | ||||
Pin 3: Signal 1 (LSB) | |||||
|
|
|
| ||
|
|
|
| ||
Pin 4: Signal 2 | 5 | 3 | |||
Pin 5: Signal 3 | |||||
|
|
|
| ||
Pin 6: Signal 4 | 4 |
|
|
| |
Pin 7: Signal 5 (MSB)
Pin 8: Interrupt
2 1
KODAK, CAROUSEL, TRANSVUE, EKTA- GRAPHIC and EKTAPRO are registered trademarks.
37
