Kodak 9020, 7020 Removing the slide tray in any position, Fastening or mounting the projector

Changing the slide tray (in zero position)

Always lift off the slide tray in the zero position.

The zero positioning indicator (24) lights up when the slide tray transport ring is in the zero position.

Move tray to zero position:

a)Using the slide change button on your projector or remote control units

Hold the slide transport-backwardsbutton down. The slide tray goes into rapid search and stops automatically in the zero posi- tion.

b)Using the IR Remote Control

Select "0" on the keypad and confirm with "*". The slide tray moves to the zero posi- tion.

c) Using the mains switch

Turn the projector off by the mains switch (34). When the projector is turned on again, it will complete a system check and bring the slide tray back to the zero posi- tion!

Removing the slide tray (in any position)

In an emergency, e.g. transport failure, the tray can be removed from the projector in any position:

3.

2.

•First switch off your projector!

1. Push aside and hold the slide tray lock (14) while -

2. - lifting off the slide tray.

3.Having removed the slide tray turn it over and rotate the base plate until it locks into the zero-position, otherwise the slide tray cannot be replaced on the projector in the zero position.

.Turn the projector on again. The slide remaining in the slide gate will be ejected by the slide lift and can be replaced in the slide tray.

Fastening or mounting the projector

To reduce vibration or for secu- rity you will find fixing holes suitable for inserts (M5) in the baseplate of the projector (see figure).

29