Checking the Engine Oil Level
Service Interval: Before each use or daily
1.Remove the dipstick, wipe it clean, and fully install the dipstick (Figure 17).
Note: To raise the mower, move all 4 cutting height levers forward; to lower the mower, move them all rearward.
Figure 17
2.Remove the dipstick and check the oil level (Figure 17). If the oil level is below the Add mark on the dipstick, slowly pour oil into the oil fill tube to raise the oil level to the Full mark on the dipstick. Do not overfill. (Max. fill: 0.6 l, type: SAE 30 detergent oil)
3.Install the dipstick securely.
Adjusting the Cutting Height
Adjusting the cutting height may bring you into contact with the moving cutterblade, causing serious injury.
•Stop the engine and wait for all moving parts to stop.
•Do not put your fingers under the housing when adjusting the cutting height.
If the engine has been running, the exhaust guard will be hot and can severely burn you. Keep away from the hot exhaust guard.
Adjust the cutting height as desired. Set all four wheels to the same height.
Figure 18
Adjusting the Upper Handle Height
You may raise or lower the upper handle to a position comfortable for you.
Note: You cannot raise the upper handle higher than the angle of the lower handle.
1. Loosen the upper handle knob (Figure 19).
Figure 19
2.Move the upper handle to the desired position (Figure 20).
11
