Blade Maintenance | cutterblade to point toward the mower housing. | |
|
| Important: Position the curved ends of the |
Replacing the Cutterblade | 6. Use a torque wrench to tighten the cutterblade | |
bolt to 60 | ||
Service Interval: Yearly | Important: A bolt torqued to 60 | |
Important: You will need a torque wrench to install | is very tight. While holding the cutterblade with | |
the cutterblade properly. If you do not have a torque | a block of wood, put your weight behind the | |
wrench or are uncomfortable performing this | ratchet or wrench and tighten the bolt securely. | |
procedure, contact an Authorised Service Dealer. | This bolt is very difficult to overtighten. | |
Examine the cutterblade whenever you run out of |
| |
petrol. If the cutterblade is damaged or cracked, replace |
| |
it immediately. If the cutterblade edge is dull or nicked, |
| |
have it sharpened or replace it. |
| |
|
|
|
|
|
|
The cutterblade is sharp; contacting the cutterblade can result in serious personal injury.
Wear gloves when servicing the cutterblade.
1.Disconnect the spark plug lead from the spark plug. Refer to Preparing for Maintenance.
2.Tip the mower onto its side, with the air filter up.
3.Use a block of wood to hold the cutterblade steady (Figure 51).
Figure 51
4.Remove the cutterblade, keeping all mounting parts.
5.Install the new cutterblade and all mounting parts.
22
