GB

ASSEMBLY

The following assembly work must be carried out before the first operation:

1.Installation of the wheels.

2.Installation of the steering wheel.

3.Installation of the driver's seat.

4.Assembly of the grass box

5.Fitting the grass box to the lawn tractor.

Attention!

Putting into operation (even test operation) before complete assembly has taken place is strictly forbidden - dangers of accidents!

The information on directions (right, left, top etc.) for this appliance are to be understood in the direction of travel looking from the driver's seat.

The order of assembly steps is to be complied with, as otherwise flawless function cannot be guaranteed.

Please note:

The figures stated to the left of the text, such as the 10

here, refer to the illustrations in the illustrated part at the front.

Front wheels:

Lock both front wheels.

6

Lift tractor slightly by bumper and pull to front wheel.

 

7

Push washer toward wheel rim.

 

 

Insert lock washer into shaft groove before washer and

8

press down.

2x lock washer dia. 15x29x1.5 - contained in screw/bolt bag.

 

 

9

Fit cover cap.

 

Rear wheels:

Lock both rear wheels.

 

Move tractor to rear wheel until rear wheel is heard to strike

10

steering knuckle.

 

 

11

Wheel axle protrudes from rim.

 

O-ring Ø11 x 2.6 is fitted in the works –

12

(secures the parallel key).

13

Remove O-ring - do not re-use

 

Fit one washer

14

1x

19 mm dia. x 26 mm dia. and

 

1x

20 mm dia. x 42 mm dia.

 

each on axle - first 19 mm dia. x 26 mm dia.!

15

Insert lock washer in shaft groove and press down.

 

16

Fit cover cap.

 

Assembly of the steering wheel

Point the front wheels straight ahead in the direction of

17 movement.

Push the 8 x 60 ∅ clamping sleeve about 10 mm into the bore of the steering wheel hub.

Put the steering wheel onto the steering column.

Ensure the correct position: the spoke is to point towards the driver's seat.

Put the round iron (7 x 150 mm ∅) of the enclosed spark plug connector into the free bore of the steering wheel hub. Turn the steering wheel until the round iron can be pushed through the bore of the steering wheel.

Connect with steering wheel with the steering column by pushing in the 8 x 60 ∅ clamping bolt.

Installing the driver's seat

18

Unscrew the driver's seal according to the diagram on the

hinged console.

 

 

 

 

n Hexagonal recess hole screw M8 x 20

(2 x)

 

Fan-disk Ø 8.4 x Ø 15

(2 x)

Disk Ø 8.4 x Ø 24

(2 x)

Spacer bushing Ø 8.2 x Ø 14

(2 x)

oHexagonal recess hole screw /

Wing screw M8 x 20

(2 x)

Fan-disk Ø 8.4 x Ø 15

(2 x)

Push the seat into the required position and tighten the screws by means of the enclosed socket wrench – 6 mm (Allen key)!

The seat can be moved in a longitudinal direction by loosening the screw o.

GB 11