Health O Meter 2000KL operation manual Assembly Instructions

ASSEMBLY INSTRUCTIONS

Figure 5

15.Hang the Load Cell Assembly on the two hooks at the end of the Lifter Boom, using the loops on top of the Load Cell Assembly.

16.Connect the end of the Load Cell Cable coming out of the center of the Load Cell Assembly to its port in the Lifter Boom.

17Use the two washers and shoulder screws to connect the two Stretcher Hoops to the Load Cell Assembly and tighten well.

18.Connect the two right stretcher bars by screwing them onto one Stretcher Bar Connector, in order to make one long Stretcher Bar.

19.Repeat step 9 with the left Stretcher Bar.

20.Insert the two bars into the open side of the channel-pockets in the Stretcher Sheet and through the two hanging loops sewn into both sides of the Stretcher. The Stretcher Bars should not protrude from the Stretcher Sheet at either end. Make sure one end on both channel-pockets is sealed with Velcro.

Note: Make sure the bars are inserted into the two hanging loops sewn on both sides of the stretcher. This will ensure that the Stretcher Bars hang correctly from the hanging loops.

9