4.Set the Seat Bracket (3) in the Seat Frame (4), and align the holes. Attach the Seat Bracket with four M8 x 16mm Bolts (87) and four M8 x 20mm Washers (10).
Be careful to avoid pinching the Pulse Wire (71). Connect the Pulse Wire (71) to the Lower Pulse Wire (92).
5.While another person holds the Upright (5) near the Frame (1), connect the Upper Wire Harness (77) to the Lower Wire Harness (66). Next, connect the Upper Pulse Wire (75) to the Center Pulse Wire (88). Insert the excess wire into the Frame.
Slide the Upright (5) onto the Frame (1). Attach the Upright with three M8 x 16mm Screws (62) and three M8 Curved Washers (107). Be careful to avoid pinching the wires.
6.The Console (76) requires four “C” batteries (not included); alkaline batteries are recommended. Insert four batteries into the back of the Console. Make sure that the batteries are oriented as shown by the markings inside of the Console.
While another person holds the Console (76) near the Console Bracket (6), feed the console wires through the large hole in the Console Bracket. Next, connect the console wires to the Upper Wire Harness (77) and the Upper Pulse Wire (75). Then, insert all wires into the top of the Upright (5).
Attach the Console (76) to the Console Bracket (6) with four M4 x 12mm Screws (106).
6
4 |
|
|
|
71 | 10 | 3 |
|
10 | 87 |
| |
| 10 |
| |
87 |
|
| |
4 |
|
| |
92 |
|
|
|
5 |
|
|
|
| 5 |
| 62 |
62 | 107 | 107 | |
| 75 | 77 | 62 |
| 88 | 66 |
|
|
| 1 |
|
6 |
| 76 | |
75 |
| ||
77 |
|
|
|
106 | 6 |
|
|
|
|
| |
| 5 106 |
|
|
