1.Attach the Rear Stabilizer (4) to the Frame (1) with two M10 x 105mm Carriage Bolts (34) and two M10 Nylon Locknuts (29).
2.Hold the Lower Wire Harness (65) in the indicated slot in the Frame (1), and insert the Front Stabilizer (3) into the Frame. Make sure that the Front Stabilizer is oriented as shown. Be careful to avoid pinching the Lower Wire Harness. Carefully tip the elliptical exerciser onto one side, and attach the Front Stabilizer with four M10 x 22mm Button Screws (21) and four M10 Split Washers (67).
3.While another person holds the Upright (2) near the Frame (1), connect the Upper Wire Harness (79) to the Lower Wire Harness (65). Carefully pull the upper end of the Upper Wire Harness to remove any slack, and set the Upright on the Front Stabilizer
(3) and the Frame. Be careful to avoid pinching the Wire Harnesses. Align the holes in the Upright with the holes in the Front Stabilizer and the Frame.
Carefully tip the elliptical exerciser onto one side, and attach the Upright (2) to the Front Stabilizer (3) and the Frame (1) with four M10 x 58mm Button Screws
(19) and four M10 Split Washers (67).
4.Gently separate the Left and Right Frame Covers (30, 81). Hold the Frame Covers around the Upright (2) and the Frame (1). Firmly press the Frame Covers together.
6
1 |
|
|
| 29 | 1 |
| 29 |
|
| 4 | 34 |
2 |
|
|
| 65 |
|
| Slot |
|
3 | 1 |
|
| 67 |
|
| 67 |
|
| 21 |
|
3 | 2 |
|
|
| |
| 79 |
|
3 | 65 |
|
|
| |
| 1 |
|
67 |
|
|
| 67 |
|
| 19 |
|
4 |
|
|
| 81 |
|
2 |
|
|
30 |
|
|
| 1 |
|
