Healthrider HRMSEL2105.0 manual Insert the Console Bracket 26 into the Upright

5.If the Upper Wire Harness (79) is not already routed through the Console Bracket (26), locate the wire extending from the bottom of the Console Bracket. Carefully pull the upper end of the Upper Wire Harness to remove any slack, and tie the wire around the Upper Wire Harness as shown in the inset draw- ing. Next, carefully pull the wire up through the Console Bracket until the Upper Wire Harness is extending from the top of the Console Bracket. Then, untie the wire and discard it.

Insert the Console Bracket (26) into the Upright (2).

Be careful to avoid pinching the Upper Wire Harness (79). Attach the Console Bracket with three M8 x 25mm Button Screws (57) and three M8 Split Washers (74).

6.If the end of the indicated ground wire is not already attached to the Console Bracket (26), attach the ground wire with an M5 x 15mm Screw (89) as shown.

While another person holds the Console (5) near the Console Bracket (26), connect the wires on the Console to the Upper Wire Harness (79) and the Pulse Wire Harness (80). Insert the Wire Harnesses down into the Console Bracket.

Attach the Console (5) to the Console Bracket (26) with four M4 x 16mm Screws (66). Be careful to avoid pinching the wire harnesses.

Attach the Water Bottle Holder (63) to the Upright (2) with two M4 x 19mm Screws (39).

7.The Console (5) requires four 1.5V “D” batteries (not included); alkaline batteries are recommended.

Look under the Console (5) and locate the battery cover. (Note: For clarity, the drawing shows the Console removed from the elliptical exerciser.) Press the tab on the battery cover and remove the battery cover. Next, insert four batteries into the Console; make sure that the batteries are oriented as shown by the diagram inside of the Console. Then, reattach the battery cover to the Console.

5		Wire
	26	79
	79
	57
	74
	74	57
	2
6
		5
	Console
	Wires
	79
	80
		89
	26	Ground
		Wire
	66	63
	2
		39
7	5
	Batteries
	Battery
	Cover

7