ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with
Assembly requires the included hex key | and your own phillips screwdriver | (with a |
shaft at least 6" long) and wire cutters | . |
|
Use the drawings below to identify the hardware used during assembly. Note: If a part is not in the parts bag, check to see if it has been preattached to one of the parts to be assembled. To avoid damaging plastic parts, do not use power tools for assembly.
Ground Screw | Screw |
|
| 2 1/4" Extension Leg Bolt | |
|
| |
| Star Washer |
|
Front Endcap |
|
|
Screw |
| 2 1/2" Extension Leg Bolt |
|
| |
1" Tek Screw | Extension Leg Nut | Handrail Bolt |
1. Make sure that the power cord is unplugged. | 1 |
|
|
| |
With the help of a second person, carefully tip |
|
|
the treadmill onto its left side as shown. Partially | 84 | 14 |
fold the Frame (58) so the treadmill is more sta- |
|
|
ble. Do not fully fold the Frame until the |
| 44 |
treadmill is completely assembled. |
| |
|
| |
Insert an Extension Leg (89) into the base of the | 92 |
|
|
| |
Uprights (84). Hold an Extension Leg Nut (67) in | 8 |
|
the bottom of the Extension Leg, and thread a |
| |
|
| |
2 1/4” Extension Leg Bolt (92) with a Star |
| 8 |
Washer (8) into the top of the Extension Leg. |
|
|
Next, thread a 2 1/2” Extension Leg Bolt (65) with |
| 67 |
a Star Washer (8) into the bottom of the | 89 | |
Extension leg. Firmly tighten the Extension |
| 65 |
Leg Bolts. |
| |
58 |
| |
|
| |
Slide a Front Endcap (44) onto the base of the |
|
|
Uprights (84). Finger tighten a Front Endcap |
|
|
Screw (14) into the Front Endcap and the base. |
|
|
| 6 |
|
