R
Page 16 September 1, 2008
Isle Royale Wood Stove
250-5763C
Spark Arestor Cap
Roof Flashing
Storm Collar
Joist Shield/Firestop Listed Chimney
Connector
Floor Protector
Outside Air Kit Connector
Outside Air Floor Vent
1. An outside air inlet must be provided for combustion and must remain
clear of leaves, debris, ice and/or snow. It must be unrestricted while
stove is in use to prevent room air starvation which can cause smoke
spillage and an inability to maintain a re. Smoke spillage can also
set off smoke alarms.
2. Stove
must be secured to the mobile home structure. Use 1/4 inch
(6mm) lag bolts with the appropriate length for your installation to secure
stove through pad and into oor.
3. Stove must be grounded with #8 solid copper grounding wire
or equivalent and terminated at each end with N.E.C. approved
grounding device.
4. Stove must be installed with an approved UL103 HT ventilated
chimney connector, UL103 HT chimney, and terminal cap with spark
arrestor. Never use a single wall connector (stove pipe) in a mobile
home installation. Use only double-wall connector pipe, Dura-Vent
DVL, Selkirk metalbestos DS, Security DL double wall connector or
any listed double wall pipe connector.
5. Refer to page 6 of this manual or the Serial Number label on the
back of the stove for clearances to combustibles.
6. Floor protections requirements on page 7 must be followed
precisely.
7. In Canada, this appliance must be connected to a 6 inch (152mm)
factory-built chimney conforming to CAN/ULC-629M, STANDARD
FOR FACTORY BUILT CHIMNEYS. Floor protection referenced on
page 7 must be followed.
8. Use silicone to create an effective vapor barrier at the location
where the chimney or other component penetrates to the exterior
of the structure.
9.
Follow the chimney and chimney connector manufacturer’s instructions
when installing the ue system for use in a mobile home.
NOTE: Offsets from the vertical, not exceeding 45°, are allowed per
Section 905(a) of the Uniform Mechanical Code (UMC). Offsets
greater than 45° are considered horizontal and are also allowed,
providing the horizontal run does not exceed 75% of the vertical
height of the vent. Construction, clearance and termination must
be in compliance with the UMC Table 9C. This installation also
complies with NFPA 211.
MOBILE HOME INSTALLATION
WARNING: NEVER DRAW COMBUSTION AIR
FROM A WALL, FLOOR OR CEILING CAVITY
OR FROM ANY ENCLOSED SPACE SUCH AS
AN ATTIC OR GARAGE.
CAUTION: THE STRUCTURAL INTEGRITY
OF THE MOBILE HOME FLOOR, WALL AND
CEILING/ROOF MUST BE MAINTAINED. (i.e.,
DO NOT CUT THROUGH FLOOR JOIST, WALL
STUD, CEILING TRUSS, ETC.)

WARNING: DO NOT INSTALL

IN SLEEPING ROOM.

You must use a Quadra-Fire Outside Air Kit Part 831-1780 for installation in a mobile home.

NOTE: Top sections of chimney must be removable to allow maximum clearance of 13.5 ft. (411cm) from ground level for
transportation purposes.
10. Burn wood only. Other types of fuels may generate poisonous gases (e.g., carbon monoxide).
11 If unit burns poorly while exhaust blower is on in home, (i.e. kitchen range hood) increase combustion air.