Page 3
Isle Royale Wood Stove
R
September 1, 2008 250-5763C
Serial Number Label Location .................................2
Pre-Use Checklist .....................................................3
Listings & Safety Notices ........................................4
Dimensions ...............................................................5
Vent Specications...................................................5
Clearances
Top & rear vent installations .................................6
Floor protection ....................................................7
Locating your stove ..............................................8
Alternate oor protection calculation ....................8
Installation
Reversible ue collar ............................................9
Rear ue deector cover plate .............................9
Chimney height requirements & draft ..................10
2-10-3 Rule ..........................................................10
Flue & venting systems ........................................11
Chimney connector ..............................................11
Masonry chimney .................................................11
Solid pack chimney with
Metal supports as a thimble.............................12-13
Masonry replace .................................................14
Metal prefabricated chimney ................................15
Mobile home installation ......................................16
Outside air kit installation .....................................17
Optional Blower ...................................................17
Operation
Over-ring Your Appliance ...................................18
Burning process ...................................................18
Air controls ...........................................................19
Heat output setting ...............................................20
Operation of top-load option ................................20
Building a re .......................................................21
Opacity .................................................................21
Burn rates ............................................................22
Wood selection and storage.................................22
Blower operating instructions ...............................22
Maintenance
Creosote formation & removal .............................23
Chimney cleaning ................................................23
Ash removal .........................................................23
Overfring ..............................................................23
Firebrick ...............................................................23
Glass care & replacement ....................................24
Plated Surfaces ....................................................24
Brick replacement ................................................25
Door & gasket .....................................................25
Service & Maintenance Log .....................................26
Exploded views.........................................................27
Service Part & Accessories .....................................28
Warranty................................................................30-31
Contact Information .................................................32
TABLE OF CONTENTS

PRE-USE CHECK LIST

CAUTION!
DO NOT TILT THE UNIT ON THE CAST IRON LEGS.
Lift the unit upright and place it into position on the oor
protector.
1. Place the unit in a location near the nal instal-
lation area and follow the procedures below.
2. Open the stove and remove all the parts and
articles packed inside. Inspect all the parts and
cast iron body for shipping damage. Contact
your dealer if any irregularities are noticed.
3. All safety warning have been read and fol-
lowed.
4. This Owner's Manual has been read.
5. Floor protection requirements have been met.
6. Chimney connector is properly installed.
7. The proper clearances from the stove and chim-
ney to combustibles materials have been met.
8. The masonry chimney is inspected by a pro-
fessional and is clean, or the factory-built
metal chimney is installed according to the
manufactuer'rs instrucitons and clearances.
9. The chimney meets the required minimum
height.
10. All labels have been removed from the glass
doors.
11. Plated surfaces have been wiped clean.