Hearth & Home Technologies Inc. 800 W.
Jefferson, Lake City, MN 55041.
CAUTION:
Although the glass is safety glass, it may break if dropped, bumped or struck. Care must be taken when handling the glass.
4.Heater System Maintenance
a.Turn off the circuit breaker/unplug the appliance before servicing the heater system.
b.Allow appliance to cool before removing.
c.Remove the hood by pulling it straight out.
d.Remove the upper panel/door front by lifting it up and out.
e.Remove the four outer screws. See Figure 13.
f.Pull the heater system out of appliance. With the heater system out of the appliance, reach into the back of the appliance and unplug wire harness from connector. To remove the plug, squeeze both sides and pull.
g.Slide the heater system back into the appliance, making sure that the wires do not touch the heater housing. If the heater system is not locked on the clip the front will not be flush.
h.Once the front of the heater system is flush with appliance, reinstall the four screws removed earlier.
i.Replace the upper panel and hood.
j.Turn on circuit breaker when heater installation is complete.
k.Follow the operating instructions found in section “I. Operaing Instructions”.
Figure 13
Installing the Heater
15 | CRESTFIRE SERIES ELECTRIC FIREPLACE |
10/03
