Hearth and Home Technologies Cinch Pipe & Termination Cap System Assemble Vent Sections

C. Assemble Vent Sections

WARNING

Fire Risk

Exhaust Fumes Risk

•Overlap pipe slip sections at least 1-1/2 inches.

•Use pilot holes for screws.

•Screws must not exceed one inch long.

•Pipe may separate if not properly joined.

Attaching Vent to the Firebox Assembly

To attach the fi rst pipe section to the collars, slide the male end of the inner vent of the pipe section over the inner collar on the fi rebox assembly. At the same time, slide the outer

flue over the outer collar on the appliance. Push the pipe section into the appliance collar until all the lances (see Fig- ure 2.5) have snapped in place. Tug slightly on the section to confi rm it has completely locked into place.

Assemble Pipe Sections

Insert the inner fl ue of section A into the fl ared inner fl ue of section B.

Start the outer fl ue of section A over the outer fl ue of section B (see Figure 2.6).

Note: The end of the pipe sections with the lances/tabs on it will face towards the appliance.

Once both inner and outer fl ues are started, press section A onto section B fi rmly until all lances have snapped into place. Check to make sure they have snapped together (see Figure 2.7) and the seams are not aligned (see Figure 2.8). Tug slightly on section A to confi rm it has completely locked into place.

For 90° and 45° elbows that are changing the vent direction from horizontal to vertical, one screw minimum should be put in the outer fl ue at the horizontal elbow joint to prevent the elbow from rotating.

Figure 2.5 Lances

	A
			A
			B
	B
Figure 2.6 Inner/Outer		Figure 2.7 Snapped

Make sure the seams are not aligned to prevent unintentional disconnection.

CORRECTINCORRECT

Figure 2.8 Seams

6Hearth & Home Technologies Inc. • Cinch Pipe & Term Caps • 4033-900 Rev K • 05/05