Manuals / Hearth and Home Technologies / Household Appliance / Indoor Fireplace

Hearth and Home Technologies EC36 manual Complete the Enclosure, Gas Log/Lighter Provisions

Models: EC36

1 32
Download 32 pages 49.84 Kb
Page 19
Image 19

EC SERIES INSTALLATION INSTRUCTIONS

15. Complete the Enclosure

Complete the fireplace enclosure, allowing space for outside air ducts and gas piping if desired. Electrical wiring should not come in contact with the fireplace. A minimum clearance of 1/2 in. must be maintained between the fireplace sides and the enclosure as well as the fireplace back and the enclosure. See pages 10-12 for framing details.

Note: Use only a noncombustible material to finish the face of the fireplace below the level of the front standoffs. A noncombustible material such as USG MICORE CV230 Mineral Fiber Board, or USG DUROCK Cement Board is recommended for this purpose.

CAUTION:

When using a gas log set, the fireplace damper must be set in the fully open position. This en- sures proper venting of combustion products.

16. Gas Log/Lighter Provisions

Knockouts are provided on both sides of the fireplace to allow for connection of a certified gas log lighter or a decorative gas appliance with a maximum input of 100,000 BTU/hour, incorporating an automatic gas shut-off device and complying with the Standard for Decorative Gas Appliances for Installation in Vented Fireplaces, ANSI Z21.60. The decorative gas appliance should be installed in accordance with the National Fuel Gas Code, ANSI Z223.1-1980. The side refractories are designed to allow 1/2 in. iron pipe to pass through. Use a noncombustible sealant to seal any opening between the gas pipe and refractory on the inside. Repack the insulation removed to seal around the gas pipe where it exits the side of the fireplace. A minimum 1-1/2 in. air clearance must be provided around the 1/2 in. iron pipe for a minimum of 4 in. beyond the fireplace. See Figure 16.

WARNING!

This fireplace was not tested by the fireplace manufacturer for use with an unvented gas log heater. To reduce risk of injury, do not install an unvented gas log heater in this fireplace unless it has been specifically tested and listed by Underwriter’s Laboratories Inc. for use in this specific model fireplace. Unless the unvented gas log heater is tested and listed for use in this factory built fireplace, a fire hazard may be created that can result in a structure fire.

Figure 16 - Air Clearance Around Gas Line

CLEARANCES!

A minimum 1/2 in. air clearance must be maintained at the back and sides of the fireplace assembly.

Chimney sections at any level require a 2 in. minimum air space clearance between the framing and chimney section.

08/04

17339 Rev L

19

Page 18 Page 20
Page 19
Image 19
Hearth and Home Technologies EC36 manual Complete the Enclosure, Gas Log/Lighter Provisions
Page 18 Page 20

EC36 specifications

Hearth and Home Technologies EC36 is a well-regarded product in the realm of modern heating solutions, appealing to consumers seeking a combination of efficiency, aesthetics, and advanced technology. Aimed at both form and function, the EC36 is perfectly suited for today’s homes, blending seamlessly into various interior designs while providing exceptional warmth.

One of the defining features of the EC36 is its efficient heating capacity. With a maximum output of 36,000 BTUs, this unit provides considerable heat for areas up to 1,200 square feet. This makes it an ideal choice for medium to large living spaces, ensuring that your home remains cozy during the coldest months. The innovative design of the EC36 enhances heat distribution, allowing for consistent warmth throughout a room.

The technology behind the EC36 is equally impressive. It utilizes advanced burning technology which promotes efficiency and minimizes emissions. The unit is equipped with a sealed combustion system, allowing it to draw outside air for combustion, rather than using the indoor air. This not only improves efficiency but also enhances air quality within the home. The EC36 is engineered to meet or exceed environmental standards, making it a responsible choice for eco-conscious consumers.

Another characteristic worth noting is the customizable aesthetic of the EC36. The unit is available in various finishes, allowing homeowners to select a style that complements their décor. From sleek black to traditional finishes, the EC36 easily integrates into any design scheme. Additionally, the large viewing window provides a beautiful showcase of the flames, creating an inviting atmosphere.

The operation of the EC36 is designed with user convenience in mind. It features an easy-to-use control panel and offers optional remote control capabilities, enabling homeowners to adjust settings from across the room. The reliability of the ignition system further simplifies operation, allowing users to enjoy the warmth without the hassle.

In conclusion, Hearth and Home Technologies EC36 stands out as a robust choice for effective home heating. With its impressive BTU output, advanced burning technology, customizable aesthetics, and user-friendly operation, the EC36 not only meets but exceeds the expectations of modern homeowners seeking comfort, style, and efficiency.