Hearth and Home Technologies GBI25 Firebox Bottom Removal, Log Assembly Removal

GBI25 SERIES B-VENT GAS FIRED FIREPLACE INSERT

h.Firebox Bottom Removal

1)Shut off the gas to the appliance before removing. Remove the glass frame following instructions found in Step 3a. on page 7.

2)Remove the two screws on the log assembly (Figure 20). Pull out the log assembly (Figure

21)and place in a safe area. Remove the four screws located around the firebox bottom. See Figure 22.

3)To re-install the firebox bottom, reverse the above steps.

Figure 20 - Log Assembly Removal

Figure 22 - Firebox Bottom Removal

i.Fan Access

1)Disconnect the power cord or turn off the circuit breaker before removing the fan. Remove the firebox bottom following directions in Step 3h.

2)Remove the four screws located on the fan bracket (Figure 23). Remove two on the fan control. Remove the bushing and unplug the cord from the junction box. Slide the fan bracket out.

3)To re-install fan, reverse the above steps.

Figure 21 - Log Assembly Removal Figure 23 - Fan Removal

WARNING!

Any safety screen or guard removed for servicing an appliance must be replaced prior to operating this appliance. Clothing or other flammable material should not be placed on or near the appliance.

02-02 11 26678 Rev H