GBI25 SERIES
b.Installation of Appliance
1)The appliance should be set on a level surface. Located on the bottom pan of the appliance are two
2)Place appliance on hearth and slide the appliance into the fireplace. Position the draft tube in the hold located on the back. Reach through the exhaust hole and grab the draft hood. See Figure 7. Continue to slide appliance back until draft hood is in position. Reinstall four screws around the exhaust hole.
Figure 7
3)Place the flex line through the gas line access hole on the right side and connect it to the manual shutoff valve. Turn on the gas and check for leaks with a soap and water solution or a gas leak detector. If a leak is detected, tighten the fitting and recheck all joints.
Reinstall the baffle with two screws.
c.Surround Installation
1)Carefully remove the surround parts from the shipping carton. Attach the surround top to each side with two screws provided. See Figure 8. Located on the surrounds is a bend tab used to cover the switch leads. For Model
Figure 8 - Attach Surround Top
GSD24, the bend tab is located on the top of the right surround side. For Models GSD40 and GSD46 the bend tab is located on the right side of the top surround. Use a pair of pliers to bend the tab forward. See Figure 8.
Figure 9 - Installation of Surround Hood
Figure 10 - Installation of Surround Hood
2)For zero clearance fireplaces or fireplaces with combustible material within 12 inches of the firebox opening, it is required to use the surround hood (black). This hood is not required for masonry fireplaces. To install the surround hood, bend the tabs down, as shown in Figure 9. Place the tab through the slots in the surround top and bend the small tab over. See Figure 10.
3)Place three screws in the surround top and slide the brass hood over the screws. Remove the plastic coating on brass before securing. See Figure 11.
4)Assemble the brass trim with brackets provided, as shown in Figure 12. Slide the brass trim on the surround (Figure 13).
5)To install the surround, place hooks on the surround side into slots located on the column (Figure 14).
6)Locate the electrical cord on the left side of the appliance and route it through the surround and trim. Make sure that the electircal cord is routed away from the appliance.
26678 Rev H | 8 |
