6.Pass the leading edge of the roll over the upper rollers, and thread the cleaning material through the rollers on the left.
7.There is a strip of polyester film on the leading edge of the cleaning material. Insert it into the hole in the takeup core, which takes hold of it.
8.Slide the takeup core onto the lower axle. It clicks into place.
NOTE: If the cleaner roll has not been properly installed, you may see a message about clearing a printhead cleaning roll jam. Pull the whole assembly out, wind a little of the roll forward, then slide it back in again. The printer will check the roll again
9.Restore the pinch system by moving the black knob back into place. If you feel resistance because the cleaning roll is too tight, turn the roll slightly
10.Grip the handle and push the whole printhead cleaning roll assembly back into the printer.
11.Close the door.
ENWW | Install the printhead cleaning roll and aerosol filters 51 |
