5 Connect the power cables
Requirements
An electrician is required for the setup and configuration and building of the electrical system used to power the printer and also for printer installation. Make sure that your electrician is appropriately certified according to local regulations and supplied with all the information regarding the electrical configuration.
Configure the building's electrical system used to power the printer to meet the printer's requirements and the Electrical Code requirements of the local jurisdiction of the country where the equipment is installed. A qualified electrician is required.
Your printer requires the following electrical components to be supplied and installed by the customer, according to the Electrical Code requirements of the local jurisdiction of the country where the equipment is installed.
Remember that you are required to follow the local laws, regulations, and standards that pertain to the electrical installation of your printer.
Tri-phase AC Power Cord
The cable must meet the requirements of the printer and should be in accordance with the Electrical Code requirements of the local jurisdiction of the country where the equipment is installed.
Printer's | ||
|
|
|
Input voltage (line to line) | 3 x | 3 x |
|
|
|
Input frequency | 50 Hz | 60 Hz (1) |
|
|
|
Power Consumption | 15 KW | 15 KW |
|
|
|
Maximum Load Current | 30 A | 50 A |
1Japan may have input frequencies of 50 Hz or 60 Hz
Power Cord Specification | ||
|
|
|
Configuration | 4 Wires, L1/L2/L3/PE |
|
|
|
|
Minimum | AWG6, 16mm2 | AWG6 |
The power cord must enter into the printer through the AC power gland, and securely fit into it, in order to avoid any slip even when the cord suffers a pull force of 100N.
ENWW | Requirements 23 |
