
*2 • The video preview is not displayed when:
–HDMI IN 5/6/7 is the current HDMI input source, or
–No signal is present on the current input source.
•The video of the
*3 “Dynamic EQ” and “Dynamic Volume” cannot be selected when any of the THX listening modes is selected, with “Loudness Plus” set to “On” or “Preserve THX Settings” set to “Yes” (➔ page 66).
*4 • When the “Monitor Out” setting is set to “Sub”, “Video” cannot be selected (➔ page 61).
•This setting cannot be used with the NET, USB and BLUETOOTH input selectors.
*5 Only when you have selected “Custom” in the “Picture Mode” (➔ page 71), pressing ENTER allows you to adjust the following items via the Quick Setup: “Brightness”, “Contrast”, “Hue” and “Saturation”. Press RETURN to return to the “Picture Mode” setting.
*6 Depending on the input source and listening mode, not all channels shown here output the sound.
*7 • This setting is not available in either of the following cases:
–The “Audio TV Out (Main)” setting is set to “On”
(➔ page 75) or “Audio TV Out (Sub)” setting is set to “On” (➔ page 75) and you’re listening through your TV speakers.
–“HDMI CEC (RIHD)” is set to “On” (➔ page 74) and you’re listening through your TV speakers.
Explanatory Notes
a■ Phase Matching Bass
b`Off `On
aSetting target
bSetting options (default setting underlined)
Using the Audio Settings of Quick Setup
You can change various audio settings from the Quick Setup (➔ page 56).
Note
•These settings are not available in either of the following cases:
–The “Audio TV Out (Main)” setting is set to “On”
(➔ page 75) or “Audio TV Out (Sub)” setting is set to “On” (➔ page 75) and you’re listening through your TV speakers.
–“HDMI CEC (RIHD)” is set to “On” (➔ page 74) and you’re listening through your TV speakers.
Tone Control
■Bass
You can boost or cut
■Treble
You can boost or cut
You can adjust the bass and treble for the front speakers, except when the Direct, Pure Audio or THX listening mode is selected.
Operating on the AV receiver
1 | Press TONE repeatedly to select either “Bass” |
| or “Treble”. |
2 | Use – and + to adjust. |
Advanced Operations
Phase Matching Bass
■Phase Matching Bass
`Off
`On
From the warm low notes produced by a cello to the deep frequencies of electronic music, a good audio system should be able to deliver plenty of bass resonance.
While traditional enhancement systems effectively boost
Note
•The Phase Matching Bass is disabled when the Direct, Pure Audio, or THX listening mode is selected.
•If the “Subwoofer” setting is set to “No”, this setting is fixed to “Off”.
Operating on the AV receiver
1 | Press TONE repeatedly to select “Phase |
| Matching Bass”. |
2 | Use – and + to change the setting. |
En-57
Operating procedure (➔ page 56)