Onkyo TXNR828 instruction manual En-68, Source Setup, Audyssey DSX, Theater-Dimensional, LFE Level

■TrueHD Loudness Management

`Off

`On

This setting specifies whether or not to apply the Late Night processing on a Dolby TrueHD source.

Note

•When this setting is set to “Off”, the Late Night function for Dolby TrueHD sources is automatically fixed to “Off”.

•When this setting is set to “Off”, the Dialogue Normalization information is not available for Dolby TrueHD sources.

DTS

■Neo:6 Music

Center Image

`0 to 2 to 5

The DTS Neo:6 Music listening mode creates 6- channel surround sound from 2-channel stereo sources. With this setting, you can specify by how much the front left and right channel output is attenuated in order to create the center channel. Changing the value from “0” to “5” will spread the sound of the center channel to left and right (outwards).

Audyssey DSX®

■Soundstage

`–3dB to Reference to +3dB

With this setting, you can adjust the sound stage when using Audyssey DSX.

Note

•This listening mode can be selected only when all the following conditions are satisfied:

–The center speaker is connected.

–Either the front high or front wide speakers are connected.

–Powered Zone 2 is not in use.

Theater-Dimensional

■Listening Angle

`Wide:

Select if the listening angle is greater than 30 degrees.

`Narrow:

Select if the listening angle is less than 30 degrees.

With this setting, you can optimize the Theater- Dimensional listening mode by specifying the angle of the front left and right speakers relative to the listening position. Ideally, the front left and right speakers should be equidistant from the listening position and at an angle close to one of the two available settings.

Front left speaker	Front right speaker
	Listening angle: 30°

Note

•For best results, we recommend setting “Narrow” to 20° and “Wide” to 40°.

LFE Level

■Dolby Digital*1, DTS*2, Multich PCM, Dolby TrueHD, DTS-HD Master Audio, DSD*3

`–QdB,–20dB,–10dB, or 0dB

With these settings, you can set the level of the LFE (Low Frequency Effects) channel individually for each input sources.

If you find that low-frequency effects are too loud when using one of these sources, change the setting to –20 dB or –QdB.

*1 Dolby Digital and Dolby Digital Plus sources

Advanced Operations

*2 DTS and DTS-HD High Resolution sources

*3 DSD (Super Audio CD) sources

4. Source Setup

Items can be set individually for each input selector. Press the input selector buttons to select an input source.

Audyssey®

The tone for each speaker is set automatically by Audyssey MultEQ® Room Correction and Speaker Setup. To enable the following settings, you must first perform the Room Correction and Speaker Setup (➔ page 27).

•These technologies cannot be used when a pair of headphones is connected.

■Audyssey

`Off

`Movie:

Select this setting for movie material.

The Audyssey indicator will light.

`Music:

Select this setting for music material.

The Audyssey indicator will light.

Note

•When “Audyssey Quick Start” has been used for measurement, “Audyssey” cannot be selected.

•Audyssey equalizing does not work with DSD sources.

En-68

Operating procedure (➔ page 60)