3 Within 30 seconds, use the number buttons to enter the
The REMOTE MODE button flashes twice. If the remote control code is not entered successfully, the REMOTE MODE button will flash once slowly.
Note
•Though the provided remote control codes are correct at the time of release, they are subject to change.
Remapping Colored Buttons
You can change the configuration of colored buttons, with which REMOTE MODE buttons are preset.
1 While holding down the REMOTE MODE button that you want to program, press and hold down A (Red) until the REMOTE MODE button lights (about 3 seconds).
You can only change colored buttons for components whose codes belong to categories of the Remote Control Codes list (BD/DVD player, TV, cable
2 Within 30 seconds, press the colored buttons in the order that you want to reassign them.
The button presses are assigned to each button from left to right. The REMOTE MODE button flashes twice, indicating that the sequence has been successfully assigned. If the sequence is not successfully assigned, the REMOTE MODE button will flash once slowly.
Tip
•To reset the REMOTE MODE buttons to their default settings, see “Resetting the REMOTE MODE Buttons”.
Note
•If any other button than the colored buttons is pressed, the operation will be cancelled.
•This operation cannot be done while the AV receiver is in Receiver mode or when Zone 2/3 is active.
Remote Control Codes for Onkyo Components Connected via RI
Onkyo components that are connected via uare controlled by pointing the remote controller at the AV receiver, not the component. This allows you to control components that are out of view, in a rack, for example.
1 Make sure the Onkyo component is connected with an ucable and an analog audio cable (RCA).
See “Connecting Onkyo RI Components” for details (➔ page 23).
2 Enter the appropriate remote control code for a REMOTE MODE button, by referring to the previous section.
`42157:
Onkyo cassette tape deck with u
`81993:
Onkyo Dock with u
3 Press the REMOTE MODE button, point the remote controller at the AV receiver, and operate the component.
Controlling Onkyo components without u
If you want to control an Onkyo component by pointing the remote controller directly at it, or you want to control an Onkyo component that’s not connected via u, use the following remote control codes:
Controlling Other Components
`30627:
Onkyo DVD player without u
`71817:
Onkyo CD player without u
`32900/33100/33500: Onkyo
`32901/33104/33504: Onkyo HD DVD player
`70868:
Onkyo MD recorder without u
`71323:
Onkyo CD recorder without u
`82990:
Onkyo Dock without u
Resetting the REMOTE MODE Buttons
You can reset a REMOTE MODE button to its default remote control code.
1 While holding down the REMOTE MODE button that you want to reset, press and hold down HOME until the REMOTE MODE button lights (about 3 seconds).
2 Within 30 seconds, press the REMOTE MODE button again.
The REMOTE MODE button flashes twice, indicating that the button has been reset.
Each REMOTE MODE button is preprogrammed with a remote control code. When a button is reset, its preprogrammed code is restored.
Note
• The learning command is also reset.
