![](/images/new-backgrounds/1001454/1454105x1.webp)
Changing the Input Display
When you connect an
This setting can be done only from the front panel.
1 Press TV/CD or GAME1.
“TV/CD” or “GAME1” appears on the AV receiver’s display.
2 Press and hold down the same button (about
3 seconds) to change the input display.
Repeat this step to select the desired input
display. |
|
|
|
■ TV/CD: | TV/CD → DOCK | ||
| → |
|
|
|
|
| |
|
| TAPE | |
|
| → | |
■ GAME1: | GAME1 ↔ DOCK |
“
Note
•“DOCK” can be selected for the “TV/CD” or “GAME1” input selector, but not at the same time.
•Enter the appropriate remote control code before using the remote controller for the first time (➔ page 83).
Muting the AV Receiver
You can temporarily mute the output of the AV receiver.
1 Press RECEIVER followed by MUTING.
The output is muted and the MUTING indicator flashes on the AV receiver’s display.
Tip
•To unmute, press MUTING again or adjust the volume.
•Muting is automatically cancelled when the AV receiver is set to standby.
Selecting Speaker Layout
You can set which speakers you want to use by priority.
1 Press RECEIVER followed by SP (speaker layout) repeatedly to select:
`Speaker Layout:FH:
The sound from front high speakers is output by priority.
`Speaker Layout:FW:
The sound from front wide speakers is output by priority.
`Speaker Layout:SB:
The sound from surround back speakers is output by priority.
Note
•This setting is not available in either of the following cases:
–The “Speakers Type(Front)” setting is set to
–The “Powered Zone 2” setting is set to “Yes” and Zone 2 is turned on.
•Playback conditions may be limited depending on the settings in “Speaker Settings” (➔ page 63) and “Speaker Configuration” (➔ page 64).
•When a listening mode which doesn’t support front high, front wide or surround back speakers is used, this setting cannot be selected.
Playback
Using the Whole House Mode
The Whole House Mode is useful when you want to add extra background music to your home party; this allows you to enjoy the same stereo music as the main room in separate rooms (Zone 2/3).
The Whole House Mode selects the same input source for Multi Zone as the main room’s.
See also:
•“2. Speaker Setup” (➔ page 63)
•“Multi Zone” (➔ page 79)
1 Press WHOLE HOUSE MODE on the front panel.
To cancel the Whole House Mode, change the input source for the main room or select a listening mode (➔ page 44).
Note
•The Whole House Mode only supports analog audio and audio from NET or USB input selector.
•To adjust the volume of Multi Zone, switch the AV receiver to Multi Zone control. See “Adjusting the Volume for Zone 2” (➔ page 80) for the volume adjustment of Multi Zone.
•The Whole House Mode is not available in either of the following cases:
–The “Audio TV Out (Main)” setting is set to “On”
(➔ page 75) or “Audio TV Out (Sub)” setting is set to “On” (➔ page 75) and you’re listening through your TV speakers.
–“HDMI CEC (RIHD)” is set to “On” (➔ page 74) and you’re listening through your TV speakers.
–a pair of headphones is connected.