Onkyo TXNR828 instruction manual En-78, Remote Controller Setup, Lock Setup

■Bluetooth

This setting enables the AV receiver to pair with Bluetooth-enabled device.

Status

Press ENTER button to display “Now Pairing” and start pairing.

Tip

•If pairing setting is not set, “Ready” appears on-screen display. The name of the device paired with the AV receiver is displayed if pairing setting is set.

•For details on the Bluetooth connection, refer to the instruction manual of the Bluetooth-enabled device.

•The pairing can be done by holding down BLUETOOTH button on the AV receiver until BLUETOOTH indicator flashes.

Note

•This setting cannot be selected if you’ve selected NET or USB as input selector in Multi Zone.

Initial Setup

If you skipped the initial setup wizard, for example on first-time use, you can reaccess it from here.

See “Initial Setup” (➔ page 25).

Note

•This setting cannot be selected if the “Monitor Out” setting is set to “Sub”.

8. Remote Controller Setup

Remote ID

■Remote ID

`1, 2, or 3

When several Onkyo components are used in the same room, their remote ID codes may overlap. To differentiate the AV receiver from other components, you can change its remote ID from “1”, to “2” or “3”.

Note

•If you do change the AV receiver’s remote ID, be sure to change the remote controller to the same ID (see below), otherwise, you won’t be able to control it with the remote controller.

Changing the remote controller’s ID

1	While holding down RECEIVER, press and
	hold down Q SETUP until the RECEIVER lights
	(about 3 seconds).
2	Use the number buttons to enter ID 1, 2, or 3.
	RECEIVER flashes twice.

Remote Mode Setup

See “Looking up for Remote Control Codes” (➔ page 82).

Advanced Operations

9. Lock Setup

With this preference, you can protect your settings by locking the setup menus.

■Setup

`Locked

`Unlocked

When “Locked” is selected, the setup menus will be locked and you cannot change any setting.

En-78

Operating procedure (➔ page 60)