Hearth & Home Technologies - Colville
1445 North Highway, Colville, WA
H. FINAL INSTALLATION
Remove the protective cover to access the final installation items.
Remove the lava rock and white rock from the inside of the appliance.
1. Remove the Log Assembly
Logs are attached to the grate by two
2. Remove the Grate
Remove the two screws from the grate (one on each side), lift up the grate and set it aside.
3.Install the Side Refractory
a.Remove the refractory and fasteners from the carton.
b.Take the refractory support bracket and bend it until it is “L” shaped.
c.Install the bracket to the underside of the firebox top using the screws provided. Keep the bracket loose to allow the refractory to slide in behind it.
d.Tilt the side refractory into the appliance and slide it behind the bracket. See Figure 8.
e.Tighten the bracket when the refractory is resting on the hearth and is up against the back glass.
f.Repeat for the other side.
4.Reinstall the Grate
a.Put the grate back into the appliance, making sure the middle grate bar is sitting in the back bracket.
b.Replace the screws removed in Step 2.
5.Install the Hearth Refractory
a.Place the right hearth refractory into the appliance so the outer edge fits up against the side refractory. See Figure 9.
b.Loosen (if needed) the side refractory bracket to allow the hearth refractory to sit correctly (tight against the side of the firebox). The side refractory will rest upon the hearth refractory. See Figure 10.
c.Tighten the side refractory bracket.
d.Repeat for the other side.
Figure 8
Sliding the Side Refractory Behind the Bracket
(right side shown)
Figure 9 - Hearth Refractory Going In
(right side shown)
| Figure 10 - Hearth Refractory In |
|
| (right side shown) |
|
|
|
|
VILLAGE COLLECTION ELECTRIC FIREPLACE |
| |
09/03 |
| 10 |
|
|
