![](/images/new-backgrounds/1287408/28740823x1.webp)
Troubleshooting
To check the operation of the remote:
1.Make sure receiver batteries are installed properly. If one battery is installed backward, receiver will not operate in remote mode. Be sure battery output is 5.3 volts or more. (Slide switch is independent of battery condition).
2.Be sure the transmitter’s batteries are properly installed and that the battery output is 2.7V or more.
3.Check to make sure the transmitter is communicating with the receiver.
•If the receiver beeps when the MODE button is de- pressed on the transmitter they are communicating.
•If the receiver does not beep when the MODE button is depressed on the transmitter go to Matching Secu- rity Codes.
4.Make sure the transmitter is within the 20 feet range of the receiver.
5.Positioning of the receiver is important. If the receiver is “enclosed” in a metal surround, the operation of the re- ceiver may be affected as noted below. Reposition the receiver to improve operating range. It is suggested that a heat shield be installed to protect the receiver from extreme heat. If the receiver is “enclosed” in a metal surround, this can:
•Cause the RF signal to get lost and not communi- cate with the receiver.
•Cause the working distance to be shorter than nor- mal.
NOTE: A receiver located in an area, where the ambient temperature inside the case exceeds 1300 F, will cause the
Specifications
Batteries: Transmitter - 3V 2 ea.; AAA 1.5V, Alkaline
Receiver: (4) AA
FCC ID No.’s:Transmitter -
Canadian IC ID No.’s:
Transmitter -
Service Parts
No service parts available.
Limited Warranty
This REMOTE CONTROL SYSTEM is warranted for | incidental or consequential damages. Batteries and |
12 months from the date of purchase or installation to | any damage caused by them are not covered by this |
the original purchaser to be free from defects in mate- | warranty. |
rials and workmanship. Damage to the SYSTEM | Some states, provinces, and nations do not allow |
caused by accident, misuse, abuse, or installation | exclusion or limitations of incidental or consequen- |
error whether performed by a contractor, service com- | tial damages, so the above limitations or exclusions |
pany, or owner, is not covered by this warranty. Seller | may not apply. This warranty gives you specific legal |
will not be responsible for labor charges and/or dam- | rights. You may have other rights that vary by state, |
age incurred in installation, repair, replacement or for | province or nation. |
12