12 Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the firebox.
B. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated inside the firebox or underneath in the control cavity.
C. Accessories
Install approved accessories per instructions included with accessories. See Service Parts List for appropriate accessories. Refer to Section 16.
WARNING
Shock or fire risk.
Use ONLY optional accessories approved for this appliance.
•Using
•Using
•Only Hearth & Home Technologies approved
accessories may be used safely.
D. Installing the Optional Heat-Zone-Gas Kit
1.Remove the knockout from the top of the appliance and discard it (see Figure 12.1).
2.Center the duct collar around the exposed hole and attach it to the appliance with 3 screws. Note: Do this BEFORE final positioning of the appliance.
3.Determine the location for the air register/fan housing assembly.
Reference the
KNOCKOUTS |
Figure 12.1 |
E. Ember Placement
WARNING
Explosion Risk.
•Follow ember placement instructions in manual.
•Do NOT place embers directly over burner ports.
•Replace ember material annually.
Improperly placed embers interferes with proper burner operation.
Placing the Ember Material
Ember material is shipped with this gas appliance. To place the ember material:
•Remove the ash lip (see Figure 12.2) that is located in front of the glass.
Figure 12.2. Ash Lip |
•Remove the side panels located in front of the glass.
•Remove the pull mesh firescreen by unhooking from the appliance.
•Pull and release the four glass latches (2 per side) located on the sides of the glass frame.
•Grasping the upper lip with one hand and the lower lip with the other, pull the bottom of the glass out first. Guide the bottom while letting the top drop down under the top of the opening.
•There are two types of ember shipped with the unit. Embers for the burner surface and Mystic Embers for the floor of the unit.
•Do NOT place embers between log #3 and log #4. They may disrupt the flames and are not visible.
•Place Mystic Embers on the floor of unit. Use Mystic Embers to hide the pilot wires on left side of the burner.
•Save the remaining ember materials for use during appliance servicing.
•Replace glass firescreen and door front trim on the unit.
Heat & Glo • | 35 |